LEADING EDGE IDENITIFIES EXTENSIVE NICKEL AND COBALT IN HISTORIC GALLERIES
Leading Edge Materials Corp. has announced the early opening of two historic exploration galleries in its 100% owned Bihor Sud license located in Romania, where initial inspections show significant nickel and cobalt mineralization over 100 meters. The company has identified 11 galleries with mineralization potential across the license area. Following positive geophysical and mapping work, the reopening of galleries G2, G4, and G7 has commenced, with G7 highlighting extensive mineralization. Initial drilling targets will further assess these mineralized zones to evaluate their economic viability.
- Early completion of exploration galleries indicating potential for significant mineralization.
- Initial inspections reveal over 100 meters of nickel and cobalt mineralization.
- Identification of at least 11 additional exploration targets within the license area.
- Positive progress in collaboration with Romanian state organizations and joint venture partner.
- None.
LEADING EDGE IDENITIFIES EXTENSIVE NICKEL AND COBALT IN HISTORIC GALLERIES
- Initial two historic exploration galleries opened ahead of schedule
- Initial visual inspection highlighted nickel and cobalt mineralization over 100 meters
- Field mapping indicates 11 galleries and mineralization throughout the license area
Vancouver, January 23, 2023 – Leading Edge Materials Corp. (“Leading Edge Materials” or the “Company”) (TSXV: LEM) (Nasdaq First North: LEMSE) (OTCQB: LEMIF) (FRA: 7FL) is pleased to announce that it is ahead of schedule in exploration of its exclusive and
Eric Krafft, Interim CEO of the Company, states: “We are extremely pleased with the rapid work progress to date and the support we are receiving from the involved state organizations and our Romanian JV-partner Remat. Amongst all participants in this exploration program, there is growing excitement fueled by the findings in the first reopened gallery. Following initial sampling, the Company will target underground and surface drilling to determine the extent of mineralized structures. There are at least 11 galleries accessing different mineralized structures, so there are already other identified exploration targets. Further drill targets are identified by our mapping and geophysical program, adding significant potential for mineralization beyond whatever is encountered in these initial two galleries.”
Previous mining in the license area for commodities other than cobalt and nickel left behind a vast network of galleries opening tens of kilometers of underground exposure. Verbal reports from miners working in those galleries up to 1997, as well as numerous samples retrieved from gallery waste dumps, indicate significant Co-Ni mineralization left in place ranging from disseminated, percent-grade Co-Ni in dark schist to very high-grade stringers, veins, and pods.
The Company’s prime target to reopen and explore the old galleries, forms part of the Year 2 license work program established with the Romanian National Agency of Mineral Resources (NAMR). Year 1 (ending May, 2023) foresees chiefly geophysical and mapping work, which has all been completed already with promising results.
Following receipt of the appropriate regulatory environmental and safety approvals, the Company has commenced the process of reopening of Galleries G2, G4, and G7. Galleries G4 and G7 (see Figure 1) have now been opened and made safe for commencement of planned exploration works. The “waste” dump situated outside the entrance of G7 has proven most prolific for retrieval of Co-Ni mineralized rocks, and a boulder with very high-grade, vein-style Co-Ni-sulphides was recently recovered from the G2 “waste” dump. G4 features Zn-Cu-Pb-Ag mineralization.
Figure 1; License overview map showing the principal gallery mouth locations; those currently reopened are highlighted in black (G2, G4, G7). Geophysical work consists mainly of IP (induced potential) and NP (natural potential) sections of 500 and 2000 m length. A ground magnetic survey covering these sections and G4+G7 has already been carried out by the Company in 2018.
The first reopened gallery is G7, which was inspected on January 18, 2023 by the Romanian state authority INSEMEX, responsible for mine safety matters and respective permitting. The gallery is in a very good state, which allowed the Company and its consultants to enter behind INSEMEX, so that the present mineralization could be observed and documented.
Figure 2: INSEMEX inspection team at reopened Gallery 7.
Observations in G7 highlight Co-Ni mineralization initially 425 m from the mouth of G7 and was observed until 560 m, the end of the current survey. Reconnaissance work beyond 560 m will continue once this section of the gallery is declared safe for access. Due to 30 years of exposure on the gallery walls, the original Co-Ni-minerals were oxidized, easily detectable by their typical pink (Co) and green (Ni) colours.
Disseminated mineralization follows low-dipping foliation in graphitic schists, and in often foliation-parallel high-grade veinlets, accompanied by quartz and carbonate stringers. The thickness of mineralized zones ranges from about 0.5 m to potentially thicker than 2 m, restricted by the height of the gallery. The 135m mineralized sector ( 425m to 560 m) has numerous niches and one parallel gallery, where Co-Ni mineralization is exposed in several zones following the general NNW-SSE structural trend. A second center of Co-Ni mineralization was identified in an east-directed cross-cut towards G4. The intersected vein-style and disseminated Co-Ni-zone in the cross cut appears to run parallel to the mineralization observed in G7, but is located about 400 m away. This occurrence was not followed up in the historic works and remains to be outlined in its full extent along strike.
| Figure 3 (Above): Well preserved state of G7. Most of the rails are removed. Figure 4 (Right): Powdery, greenish nickel oxide minerals on the gallery wall and rocks on the gallery floor. Yellow magnetic pen for scale. |
Figure 5: Powdery, pinkish cobalt oxide mineral on foliation in graphitic schist. Individual Co-oxide mineral grains are about 1 mm across.
Figure 6: Pinkish cobalt oxide mineral weathering from schists. Hammer for scale.
Figure 7 (Left): Piece of a Co-Ni-vein discovered 525 m from the branching point in the cross-cut from G7 towards G4. Image width: 10 cm.
Figure 8 (Right): Hand-held XRF reading on this sample: 4.76 % Co, 20.17 % Ni.
The reader is cautioned that such measurements cover only the surface of a rock with an area on the order of 1 cm2 and are neither representative, nor do they indicate reliable mineralization grades. In the context of the work performed here, this XRF-reading has the sole purpose of demonstrating the presence of cobalt and nickel in the encountered mineralization.
Joint Venture Background
In 2018 the Company entered into a share purchase agreement (the “SPA”) with a local Romanian arm’s length party, Remat, to acquire an initial
Qualified Person
Martin S. Oczlon, PhD Geol, CEngMIMMM, a consultant to Leading Edge Material and Qualified Person, as defined in NI 43-101, has reviewed and verified the technical content in this press release.
On behalf of the Board of Directors,
Leading Edge Materials Corp.
Eric Krafft, Interim CEO
For further information, please contact the Company at:
info@leadingedgematerials.com
www.leadingedgematerials.com
Follow us
Twitter: https://twitter.com/LeadingEdgeMtls
Linkedin: https://www.linkedin.com/company/leading-edge-materials-corp/
About Leading Edge Materials
Leading Edge Materials is a Canadian public company focused on developing a portfolio of critical raw material projects located in the European Union. Critical raw materials are determined as such by the European Union based on their economic importance and supply risk. They are directly linked to high growth technologies such as batteries for electromobility and energy storage and permanent magnets for electric motors and wind power that underpin the clean energy transition towards climate neutrality. The portfolio of projects includes the
Additional Information
The information was submitted for publication through the agency of the contact person set out above, on January 23, 2023 at 7:00 am Vancouver time.
Leading Edge Materials is listed on the TSXV under the symbol “LEM”, OTCQB under the symbol “LEMIF” and Nasdaq First North Stockholm under the symbol "LEMSE". Mangold Fondkommission AB is the Company’s Certified Adviser on Nasdaq First North and may be contacted via email CA@mangold.se or by phone +46 (0) 8 5030 1550.
Reader Advisory
This news release may contain statements which constitute “forward-looking information” under applicable Canadian securities laws, including statements regarding plans, intentions, beliefs and current expectations of the Company, its directors, or its officers with respect to the future business activities of the Company. The words “may”, “would”, “could”, “will”, “intend”, “plan”, “anticipate”, “believe”, “estimate”, “expect” and similar expressions, as they relate to the Company, or its management, are intended to identify such forward-looking information. Investors are cautioned that any such forward-looking information is not a guarantee of future business activities and involves risks and uncertainties, and that the Company’s future business activities may differ materially from those in the forward-looking information as a result of various factors, including, but not limited to, fluctuations in market prices, successes of the operations of the Company, continued availability of capital and financing and general economic, market or business conditions. There can be no assurances that such information will prove accurate and, therefore, readers are advised to rely on their own evaluation of such uncertainties. The Company does not assume any obligation to update any forward-looking information except as required under the applicable securities laws.
Neither the TSX Venture Exchange nor its Regulation Services Provider (as that term is defined in the policies of the TSX Venture Exchange) accept responsibility for the adequacy or accuracy of this news release.
Attachments
FAQ
What significant findings did Leading Edge Materials report on January 23, 2023?
What is the stock symbol for Leading Edge Materials on the OTCQB?
How many galleries have been identified in the Bihor Sud license area?
What measures are being taken for mineralization assessment at Bihor Sud?
